Product Description
- Light weight stock to mount to a carbine rifle (6-positions mil-spec or commercial tube)
- Fits all .223 and most .308 AR carbine style rifles
- Super Strong Glass Filled Nylon
- 21st century look
- Ergonomic
- Easy to replace and quick to install
- Uses 4 out of the 6 positions on a mil-spec or commercial tube
Features
- Available in Black or Flat Dark Earth
- Lightweight buttstock for the carbine AR, weighing in at 9.5 ounces
- Adapts To Existing Commercial and Mil-Spec Buffer Tubes
- Certain after Market Commercial Buffer Tubes that exceed 1.1172″ diameter may not fit
- Caution: the MBA-3 and MBA-4 Carbine buttstocks are not designed to be used with Large Bore Calibers such as .338 Lapua or .50 BMG applications. See MBA-1 and MBA-2 Rifle buttstocks as alternatives
- The MBA-4 Carbine buttstock is NOT interchangeable with A2 standard buffer tube. You will need to purchase a MBA-1 or MBA-2 Rifle buttstock to fit A2 tubes
Features
- Picatinny Rail
- Revolutionary Anti-Rattle Set Screw
Compatible Buffer Assemblies:
- .223 Mil-Spec Carbine Buffer Assembly
- .223 Commercial Carbine Buffer Assembly
- .308 Mil-Spec Carbine Buffer Assembly
- .308 Commercial Carbine Buffer Assembly
Additional Information
The MBA-4 does not include the following accessories, they can be purchased on our website separately in the Accessories section:
- Sling Swivels
- Carbine Buffer tube
- Carbine Buffer Body
- Carbine Spring
- Latch Plate
- Lock Ring
Caution: the MBA-3 and MBA-4 Carbine buttstocks are not designed to be used with Large Bore Calibers such as .338 Lapua or .50 BMG applications. See our MBA-1 and MBA-2 Rifle buttstocks as alternatives.
Installation Notes:
- When tightening the anti-rattle set screw, be careful not to over tighten as the threaded insert may separate from the plastic stock body
- When sliding the buttstock onto a 6-position buffer tube, the lock pin has a notch in the head of the lock pin that must line up with a tab on the stock body. Once the slot and tab are lined up, the pin can be fully retracted allowing the buttstock to slide onto the tube. The MBA-4 should slide easily without resistance. If there is any resistance, the lock pin is not fully retracted.
- Manufacturer Part Number:
- MBA-4
- Sub Category:
- Stocks
- Stock Style:
- Collapsible
- Stock Fit:
- Mil-Spec
- Material:
- Polymer